Nozzles For CO2 And Fiber Laser Cutting
Designed and produced according to OEM's quality standards, the cost-effective choice.
Copper Nozzle
The unplated copper nozzle feature in good durability and long service life. it is the typical nozzle type applied in the fiber laser cutting.
Chrome Plated Nozzle(CP):
Compared with natural copper nozzle, the bright mirror surface has stronger splash resistance, higher durability and longer service life.
Hard Chrome Plated Nozzle(HCP):
The new hard chrome plated process presents a matte chrome surface with a hardness of up to 55 degrees, providing superior durability and several times longer service life compared to the chrome plated nozzle.
Material
Strict selection of imported copper material to meet the excellent heat dissipation and conductivity so as to ensure the durability of the nozzle and extend its service life.
Dimensional Accuracy
Produced by advanced machining equipment with precise processing procedures, and high-quality QC to ensure that every product meets the technical requirements and even comparable with the imported products.
Concentricity
The concentricity of the double-layer nozzle can reach 0.02mm.
New Melting Cutting Nozzle
BFL 2.5/3.0/4.0/6.0 Bi-directional flow nozzle is suitable for cutting by nitrogen for stainless steel, aluminum alloys, etc.
●Significantly improved the quality including improved penetration and reduced burrs and color change;
●Reduced the nitrogen consumption while remarkably improving productivity;
●Unique internal nozzle geometry helps optimize the cutting performance.
BFL 10.00 Bi-directional flow nozzle is suitable for cutting by nitrogen for stainless steel, aluminum alloys, etc.
●Due to the special nozzle geometry and optimized gas flow rate, saving 40% cutting gas consumption;
●By combining high-speed cutting process with dual flow nozzles, 100% enhancing the sheet metal processing efficiency;
●Providing excellent cutting quality and retaining a wide range of cutting process parameters.
BST 3.5/5.0/6.0/7.0 (P/N LCTN03 Series) Suitable for cutting by nitrogen for stainless steel, aluminum alloys, etc.
●Suitable for lower air pressure cutting;
●Acquire better cutting corners and less burrs;
●Wide range of cutting process parameters.
HHC 2.0/3.0/4.0/5.0 （D2.0C，D3.0C,D4.0C,D5.0C） Suitable for cutting by nitrogen for stainless steel, aluminum alloys, etc.
New Type of oxygen assisted combustion cutting
HHB 1.2/1.4/1.6/1.8
●High power and full power cutting;
●Compared with the traditional double-layer nozzle, it can increase the sheet metal processing efficiency by 50%;
●Realize ultra bright surface cutting with different power and plate thicknesses.
HHS 1.2/1.4/1.5/1.6/1.7
●High power and full power cutting;
●Compared to traditional double-layer nozzles, it can increase your sheet metal processing efficiency by 50%;
●It can achieve higher positive focusing cutting, ensuring that the nozzle does not overheat and achieve bright cutting surface.
SP-S 1.2/1.3/1.4/1.5/1.6/1.7/1.8
●Better cutting end face verticality compared with the ordinary double-layer nozzle;
●Acquire high-quality cutting section with the positive focusing cutting of thick carbon steel plates.
ST-S 1.8/2.0/2.3/2.5
●Realize high power and high-speed cutting of thick carbon steel plates by negative focusing cutting;
●Higher cutting speed;
●Better cutting end face verticality compared with the ordinary double-layer nozzles.